Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A4
    4. : Engine oil and fillter replacement

Audi A4 - Video tutorial

Model: Audi A4 B6 - Years 2000-2004
Part: Engine oil
Operation: Engine oil and fillter replacement

place the car on special car platforms to facilitate access under the engine compartment: place a pan to collect the used oil immediately under the drain plug of the oil pan and unscrew the latter; while the oil is draining, intercept the filter cartridge and unscrew it (oil could also come out from here), apply clean oil on the gasket of the new filter and screw it in and tighten it manually (it is not necessary to introduce oil into the new filter); then screw the cap under the sump and fill the engine with new oil until reaching the correct level: to check the level, leave the car level.


Posted on 16 August 2023 by ScegliAuto

    Frequently Asked Questions

    • A4 2007-2016 - What is the correct amount of motor oil for the Audi A4 2.0 TDi? Read Answer
    • A4 2007-2016 - What is the amount of motor oil that goes into the Audi A4 B8 2.0 TDI? Read Answer
    • A4 2014-2023 - What is the right amount of motor oil for the Audi A4 3.0 TDI? Read Answer
    • A4 2014-2023 - What is the correct amount of motor oil for the Audi A4? Read Answer
    • A4 2000-2004 - Why did the oil light come on in the Audi A4? Read Answer
    • A4 2004-2008 - How much engine oil is needed for the Audi A4 3.0 tdi? Read Answer
    • A4 2000-2004 - Audi A4 1 9 TDI 130hp engine oil quantity? Read Answer
    • A4 2004-2008 - Where is the Audi A4 engine oil level sensor located? Read Answer
    • A4 2007-2016 - Where is the oil dipstick located in the Audi A4 B8 engine? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos