Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Disassembly of the handle and trunk opening button of the BMW 3 Series.

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Handle

In a few simple steps, we will see how to disassemble and replace the handle and opening button of the rear tailgate of the BMW X3. First, open the rear tailgate of the car and start removing the clips of the inner lining of the tailgate in order to remove it; then unscrew the internal screws of the handle, disconnecting the electrical connector of the button to remove it, as shown in the video. At this point, if necessary, replace the tailgate opening button, then reassemble the handle and the inner lining.

Posted on 21 February 2025 by ScegliAuto

Video tutorial

Related tutorials

Disassembly of the front door panel of the BMW 3 Series.
Disassembly of the front door panel of the BMW 3 Series.
BMW Serie 3 (2012-2019 / F30, F31) Today we will see the necessary instructions to disassemble and replace the front door panel of the BMW 3 Series, following these simple steps. First…
How to Remove the Exterior Door Handle of a BMW 3 Series
How to Remove the Exterior Door Handle of a BMW 3 Series
BMW Serie 3 (1990-2001 / E36) Before you begin, open the front door of your BMW 3 Series. Start by prying off and removing the side cover that protects the screw securing the exte…
Remove the Door Panel of a BMW 3 Series
Remove the Door Panel of a BMW 3 Series
BMW Serie 3 (2012-2019 / F30, F31) Remove the door panel of a BMW 3 Series (left rear side). Disconnect the battery terminals located in the engine compartment. Using a screwdriver, re…

    Frequently Asked Questions

    • Serie 3 2005-2013 - Why is the door handle of the BMW E90 locked? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos