Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Front Bearing Replacement BMW 3 Series E46

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Bearing

In this video tutorial, you will learn how to remove and replace the front bearing on a BMW 3 Series E46. First, lift the vehicle and proceed to remove the wheel: use a flathead screwdriver to remove the brake caliper spring, then use a punch to remove the brake caliper bolts and take it off. Also, remove the brake pads, and with a socket wrench, loosen the two bolts to remove the brake rotor by unscrewing the central screws. Remove the upper hub cotter pin using a screwdriver and extract the bearing! Replace it with the new one!

Updated on 18 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Axle Boot on the BMW 3 Series E46
Replacing the Front Axle Boot on the BMW 3 Series E46
BMW Serie 3 (1998-2006 / E46) Today, you will see in this video tutorial how to remove and replace the front axle boot on the BMW 3 Series E46, following the instructions below. F…
Replacement of the rear wheel bearing of the BMW 3 Series
Replacement of the rear wheel bearing of the BMW 3 Series
BMW Serie 3 (1998-2006 / E46) Today's main steps will show us how to disassemble and replace the rear wheel bearing of the BMW 3 Series. First, we lift the car and start disassemb…
How to Replace the Shift Lever Bushings on a BMW 3 Series E46
How to Replace the Shift Lever Bushings on a BMW 3 Series E46
BMW Serie 3 (1998-2006 / E46) In today's video, you will learn how to disassemble and replace the shift lever bushings on a BMW 3 Series E46 by following these simple steps. First…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos