Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How to reset the brake warning light on the Bmw 320d E46

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E46 - Years 1998-2006
Part: -board computer
Operation: How to reset the brake warning light on the Bmw 320d E46

In this video tutorial you can see how it is possible to reset the brake warning light of the BMW 320 E46, following simple steps that will guide you towards the correct management of your vehicle. On BMW cars there may be the problem of the brake wear warning light which stays on after replacing the brake pads. First you need to perform maintenance on the brakes; so if you see the brake wear warning light on, to solve this problem, make sure you have always replaced (even if the related wear indicators appear to be in good condition, fitting them correctly R-right side and L-left side. follow the procedure below: repeatedly press the brake pedal hard to make the pads adhere well Check that the brake fluid is at maximum level Start the engine with the vehicle stationary for at least thirty seconds.


Posted on 30 September 2022 by ScegliAuto

    Frequently Asked Questions

    • Serie 3 1998-2006 - What to do if the on-board computer on your BMW 3-series E46 no longer works? Read Answer
    • Serie 3 2019-2026 - How to reset the brake light on BMW 3 series? Read Answer
    • Serie 3 2005-2013 - Why does the BMW 3 Series navigator stop working? Read Answer
    • Serie 3 2012-2019 - What does the message "water in the tank" mean in my BMW 3 Series? Read Answer
    • Serie 3 2012-2019 - What to do if the brake pad reset does not work in a BMW? Read Answer
    • Serie 3 2012-2019 - What warning lights are there in the dashboard of the BMW 3 Series? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos