Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Starter Motor Removal Instructions

Model: BMW Serie 7 E38, MK 3 - Years: 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001
Part: Starter motor

See other generations:
Video tutorial

The starter motor is located on the transmission case (the starter motor pinion engages the flywheel during the ignition phase), just below the exhaust manifold; for this reason, it is protected by an aluminum heat shield. Proceed by removing the bolts that secure the starter motor flange to the transmission case.

Then, remove the heat shield and disconnect the power cables to completely take out the starter motor. If replacement is necessary, it is recommended to choose a refurbished one rather than a new one.


Updated on 17 February 2026 by ScegliAuto


Related tutorials

Replacing the Car Clutch
Replacing the Car Clutch
BMW Serie 7 (1994-2001 / E38, MK 3) The clutch's job is to disconnect the engine from the transmission to allow for gear changes. When it wears out, it needs to be replaced, and you can…
Replacing the Low-Pressure Fuel Pump Fuse
Replacing the Low-Pressure Fuel Pump Fuse
BMW Serie 7 (2001-2008 / E68, MK 4, E65, E67, E66) If you find that when pressing the ignition button the starter motor turns but the engine does not start, a possible cause could be the lack of fuel …
Instructions for Door Panel Removal
Instructions for Door Panel Removal
BMW Serie 7 (2001-2008 / E68, MK 4, E65, E67, E66) Removing the door panel is fairly simple. Start by locating the screws that secure it. Remove the caps along the armrest, the one inside the handle o…

Other guides you may be interested in

How to lower the rear seats in the Peugeot 206?

In this tutorial, you will see how to lower the rear seats in the Peugeot 206, a very simple and quick operation, for example, if you need more space in the boot. First, open both the doors and the tailgate, then unclip the seat base and position it vertically. Next, remove the horizontal partition, locate the release levers at the ends of both seatbacks, and, by operating them, lower the seatbacks. To reassemble everything, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos