Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Adjust Coilover Shocks

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Shocks

When a car is new, the shock absorber setting is very soft, typically ranging from 1 to 4. However, you can adjust it to customize the stiffness. To do this, you need to work on the compression-extension ratio, oscillating this ratio between 3 and 1. Here is the procedure to adjust the car shocks: Position the hydraulic jack directly under the strut bar, usually located near the bumper, not far from the wheel. Place an additional jack under the other wheel for safer work. Now, using the appropriate wrench, remove the wheel to expose the shock absorber. At this point, work on the threaded collar located near the hub that secures the plate with the shock absorber. This procedure is used to adjust the height of the front and rear suspension.

Updated on 28 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Preparation of Sport Suspension Shocks
Preparation of Sport Suspension Shocks
BMW Serie 3 (1998-2006 / E46) If you plan to install a new shock absorber kit with adjustable sport suspension, you will need to properly set up the shocks before installation. Ad…
Driver Airbag Disassembly Instructions
Driver Airbag Disassembly Instructions
BMW Serie 3 (1998-2006 / E46) The airbag on the steering wheel is secured by springs: simply loosen the grip of these springs to detach it. Before proceeding with disassembly, dis…
Replacing Shock Absorber Mounts
Replacing Shock Absorber Mounts
BMW Serie 3 (1998-2006 / E46) The failure and resulting noise of the front shock absorber mounts is a common issue in many BMW models. Replacing them requires disassembling the sh…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos