Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Front Headlight Assembly

Model: BMW Serie 3 E92, E90, E91 - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Headlight

See other generations:
Video tutorial

To remove the front headlight, first take off the bumper. If the bumper has a washer for the headlight, you must first remove the cover as shown in the images.

Next, unscrew the screws under the fender at the back of the bumper on both sides. To make this easier, turn the wheels toward the opposite side of where you are working.

At this point, unscrew the screws under the bumper. Lifting the vehicle off the ground will make this task easier.

The last screws to remove are located just above the grille near the hood latch. Remove the bumper, disconnecting the fog light wires as well.

Referencing the localized images, unscrew all the screws around the headlight. Remove the headlight, disconnecting the electrical connector last.

Car model: BMW E90 E92 E93 Required tools: 8mm socket wrench, T30 Torx wrench.


Updated on 22 February 2026 by ScegliAuto


Related tutorials

Disassembly and Replacement of the BMW 3 Series Headlight Assembly
Disassembly and Replacement of the BMW 3 Series Headlight Assembly
BMW Serie 3 (1998-2006 / E46) This guide briefly outlines the steps to disassemble and replace the front headlight assembly of the BMW 3 Series. First, open the hood of your car a…
Removing the Front Headlight from the BMW 3 Series
Removing the Front Headlight from the BMW 3 Series
BMW Serie 3 (1998-2006 / E46) This brief guide shows the steps to remove and replace the front headlight of the BMW 3 Series, following the instructions below. First, open the hoo…
Replacing Fog Light Bulb and Lens
Replacing Fog Light Bulb and Lens
BMW Serie 3 (1998-2006 / E46) To replace the bulb, you only need a screwdriver. To replace the bulb and lens, you must disassemble the entire light assembly. The screws are access…

Other guides you may be interested in

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos