Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chevrolet
    3. :
  3. Silverado
    4. : How do you replace the battery on the Chevrolet Silverado?

Chevrolet Silverado - Video tutorial

Model: Chevrolet Silverado MK 3 - Years 2014-2018
Part: Battery
Operation: How do you replace the battery on the Chevrolet Silverado?

In order to replace the battery in the Chevrolet Silverado, you need to open the hood and locate the device, which is located immediately under the windshield on the passenger side. In order to extract the piece it will be necessary to disconnect all the cables connected to the battery and it will also be possible to loosen the fixing screws that block it. Once all these components have been removed, the old battery can be removed and a new one can be installed. This will then have to be reconnected to the cables and fixed with bolts; at the end of the installation the bonnet can be closed.


Posted on 3 December 2022 by ScegliAuto



How to replace the battery of the Chevrolet Silverado
Chevrolet Silverado (2014-2018 / MK 3) Let's see in this guide the instructions that will allow us to disassemble and replace the battery of the Chevrolet Silverado, in simple and quick st
How do you replace the battery on the Chevrolet Silverado?
Chevrolet Silverado (2014-2018 / MK 3) In order to replace the battery of the Chevrolet Silverado, you need to open the bonnet and access the engine compartment, locating the battery which
Chevrolet Silverado MK3 battery replacement
Chevrolet Silverado (2014-2018 / MK 3) In this video tutorial we will see how to disassemble and replace the battery of the Chevrolet Silverado third series, following the instructions bel

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos