Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chevrolet
    3. :
  3. Captiva
    4. : How do you reset the Chevrolet Captiva service light?

Chevrolet Captiva - Video tutorial

Model: Chevrolet Captiva MK 1 - Years 2006-2018
Part: Checks and maintenance
Operation: How do you reset the Chevrolet Captiva service light?

In order to reset the Chevrolet Captiva's Service spy, you need to go inside the passenger compartment and hold down the accelerator pedal, while the instrument panel will be off. While holding it down, it will therefore be necessary to insert the ignition key in the relative block, turning it to turn on the instrument panel. Once this has been turned on, you will have to wait a few seconds for all the lights to go out. The Service warning light will go out last after about ten seconds; once it has been reset it will be possible to release the pedal and switch off the instrument panel.


Posted on 15 April 2023 by ScegliAuto

    Frequently Asked Questions

    • Captiva 2006-2018 - What problems does the Chevrolet Captiva have? Read Answer
    • Captiva 2006-2018 - Where is the temperature sensor located on Chevrolet Captiva? Read Answer
    • Captiva 2006-2018 - What warning lights are there in the dashboard of the Chevrolet Captiva? Read Answer
    • Captiva 2006-2018 - How to reset the service light on Chevrolet Captiva? Read Answer
    • Captiva 2006-2018 - What warning lights can be found on the Chevrolet Captiva? Read Answer
    • Captiva 2006-2018 - What are the Chevrolet Captiva dashboard warning lights? Read Answer
    • Captiva 2006-2018 - Where is the bottom cap of the oil pan on a Chevrolet Captiva? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos