|
Do it yourself
| |||
| ||||
How to replace the stabilizer bar on the Citroen C4 Aircross.
Model: Citroen C4 Aircross
MK 1
- Years:
2012, 2013, 2014, 2015, 2016, 2017
Video tutorial
Let's see how to replace the stabilizer bar (or anti-roll bar) of the Citroen C4 Aircross. Remember that after performing this operation, it is absolutely necessary to align the front wheels. Do not skip this step; otherwise, the vehicle will wear the tires unevenly in just a few hundred kilometers. Lift the car and disconnect the ends of the bar: it is secured to the frame with two supports with rubber bushings and to the suspension with two arms. Loosen the upper nut (without removing it) and disconnect the ends of the control arm. It is essential to count the number of turns to completely unscrew it from its threaded seat, a crucial operation to preserve its pre-adjustment. Locate the two "U" supports that secure the bar to the frame, held by two nuts each, which we will remove. At this point, the bar is free; slide it out from one side of the vehicle. Install the new rubber bushings without using grease, just silicone spray; insert the new bar by reconnecting the "U" supports, without tightening them completely. Mount the new ends with the same number of turns that we counted earlier. Connect the ends, insert the end pin into the hole of the suspension, then tighten according to what the workshop manual indicates: put the wheels on and perform the alignment.
Posted on 4 December 2025 by ScegliAuto
Related tutorials
Citroen C4 Aircross
(2012-2017 /
MK 1)
In this video, you will see the location of the fuse boxes and their respective diagrams in the Citroen C4 Aircross, useful in case you need to check…
Citroen C4 Aircross
(2012-2017 /
MK 1)
To adjust the clock of the Citroën C4 Aircross, you need to turn on the instrument panel by inserting the key into the corresponding slot: once the p…
Citroen C4 Aircross
(2012-2017 /
MK 1)
Below is a guide containing instructions that will allow you to remove and replace the front headlamp bulb on a Citroen C4 Aircross. First, open the …
Other guides you may be interested in
|
How to Remove the Rear Seat of a Hyundai Tucson?
To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.099
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |