Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the anti-roll bar of the Citroen Berlingo MK2

Model: Citroen Berlingo MK 2 - Years 2008-2018
Part: Anti-roll bar

To replace the anti-roll bar of the Citroen Berlingo, we lift the vehicle near the front wheel with a lift, support it on a safety stand, and remove the wheel and place it under the vehicle. We release the bracket above the nut that locks the bar to the shock absorber, clean the nut, unscrew it with a 16mm wrench while holding the pin still with a Torx 30. We repeat the operation with the lower attachment, remove the old bar and insert the new one, screw the nuts first by hand and then with the two wrenches, and finally tighten them definitively with a torque wrench set to 36 NM. We reassemble the bracket, then reassemble the wheel and lower the vehicle.

Posted on 10 July 2024 by ScegliAuto

Video tutorial

Related tutorials

Replacing Spark Plugs on Citroen Berlingo
Replacing Spark Plugs on Citroen Berlingo
Citroen Berlingo (1996-2013 / MK 1) Let’s look at replacing the spark plugs on a Citroen Berlingo. Lift the front bonnet and secure it, remove the engine cover panel, and begin disassem…
Replacement of the Citroen Berlingo antenna
Replacement of the Citroen Berlingo antenna
Citroen Berlingo (2008-2018 / MK 2) In this guide we will see the instructions that will allow us to disassemble and replace the antenna of the Citroen Berlingo, but also of the Peugeot…
Replacement of the fan resistors on Citroen Berlingo MK2
Replacement of the fan resistors on Citroen Berlingo MK2
Citroen Berlingo (2008-2018 / MK 2) In this video, we will see what the problem is with the cabin fan that only works at maximum speed on a Citroen Berlingo (or Peugeot Partner); if the…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos