Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Suspension Wishbone

Model: Dacia Logan MK 1 - Years 2004-2012
Part: Control arm

Replacing the front suspension wishbone is very easy to do: lift the vehicle on a ramp and remove the front wheel; start by disconnecting the stabiliser bar end link from the wishbone, then unscrew the bolt that secures the wishbone end link to the hub support; proceed to remove the bolts that secure the two bushes of the wishbone to the subframe, extract them and free the end link by prying with a screwdriver on the respective seat; then insert the new wishbone, tighten the respective securing bolts, use a jack to insert the end link into the hub support, then secure it with the respective bolt and finally reconnect the stabiliser bar.

Updated on 20 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the Rear Shock Absorber
Replacement of the Rear Shock Absorber
Dacia Logan (2004-2012 / MK 1) Replacing the rear shock absorber is straightforward since, unlike the front one, the spring and damper are not co-axial, so you do not need to compr…
Replacing the Anti-Roll Bar Link
Replacing the Anti-Roll Bar Link
Dacia Logan (2004-2012 / MK 1) The anti-roll bar is connected to the suspension wishbone via a link with a rubber insert that usually tends to wear out, causing noise when driving …
Replacement of the gear shift knob of the Dacia Logan
Replacement of the gear shift knob of the Dacia Logan
Dacia Logan (2012-2022 / MK 2) Below we will see the instructions that will allow us to disassemble and replace the gear shift knob of the Dacia Logan, but also of the Sandero. Fir…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos