Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Anti-Roll Bar Link

Model: Dacia Logan MK 1 - Years 2004-2012
Part: Control arm

The anti-roll bar is connected to the suspension wishbone via a link with a rubber insert that usually tends to wear out, causing noise when driving over rough surfaces. To replace this link, lift the vehicle on a ramp and remove the front wheel for better access (though this is not necessary). Then, unscrew the nut securing the link to the suspension wishbone, use a ball joint separator and a hammer to extract it from its seat, complete with the support rubber. Then, insert the new rubber and the new pin, and tighten the securing nut.

Updated on 21 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Suspension Wishbone
Replacing the Suspension Wishbone
Dacia Logan (2004-2012 / MK 1) Replacing the front suspension wishbone is very easy to do: lift the vehicle on a ramp and remove the front wheel; start by disconnecting the stabili…
How to Remove the AdBlue Warning Light on the Dacia Logan?
How to Remove the AdBlue Warning Light on the Dacia Logan?
Dacia Logan (2012-2022 / MK 2) If the AdBlue warning light has illuminated on your Dacia Logan, it means the anti-pollution fluid has reached a too low level and needs to be topped…
Guide to Replacing the Timing Belt on a Dacia Logan 1.6
Guide to Replacing the Timing Belt on a Dacia Logan 1.6
Dacia Logan (2004-2012 / MK 1) The following instructions will outline the main steps on how to remove and replace the timing belt on a Dacia Logan 1.6. First, open the engine bonn…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos