Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Panda
    4. : How to change the spark plugs of a Fiat Panda

Fiat Panda - Video tutorial

Model: Fiat Panda MK 2, 169 - Years 2003-2012
Part: Spark plugs
Operation: How to change the spark plugs of a Fiat Panda

Let's see in this video how to remove the spark plugs of a Fiat Panda. We open the engine compartment, lift the front hood, put it in safety, disconnect the battery terminals. We disassemble the soundproofing panel (air filter holder), remove the coils on the engine head with a screwdriver, immediately afterwards unscrew the spark plugs with a socket wrench; let's get them out of the head finally. We take the new spark plugs and accompany them with the socket wrench extension in the cylinder head. We tighten them and connect the power supply to each candle. Finally we close the bonnet and test the correct functioning of the same, starting the car.


Posted on 26 November 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Panda 2012-2021 - How to replace the spark plugs in the Fiat Panda? Read Answer
    • Panda 2003-2012 - How often are the spark plugs on the Fiat Panda natural power changed? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos