Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Brake Pads on Fiat Panda

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Brake pads

Loosen the wheel bolts on the affected wheel, raise the car with a jack, and fully unscrew them. Now that you are at the braking area, use pliers to remove the pin clip, then knock out the pin itself with a hammer. Leverage with a flat screwdriver or similar tool to open the caliper and easily extract the brake pads. Clean the area you are working on, then insert the new pads: be careful as they are likely thicker than the ones removed and may not fit easily. Therefore, open their seat by leveraging again with a flat screwdriver, insert them, and proceed in reverse for reassembly.

Updated on 9 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Brake Pads on a Fiat Panda 169
How to Replace the Front Brake Pads on a Fiat Panda 169
Fiat Panda (2003-2012 / 169, MK 2) This video shows the steps to remove and replace the front brake pads on a Fiat Panda 169, second series. First, remove the front wheel by lifting th…
How to Remove the Brake Pads on a Fiat Panda
How to Remove the Brake Pads on a Fiat Panda
Fiat Panda (1980-2003 / 141, MK 1) Remove the worn front brake pads from the brake disc on a Fiat Panda. Lift the car on a jack to the desired height, then remove the wheel (using a so…
How to Replace the Gear Knob on a Fiat Panda?
Fiat Panda (2003-2012 / 169, MK 2) Before you can start, sit in the driver's seat of your Fiat Panda. It is strongly advised to perform this operation with the engine off, to avoid acc…

Other guides you may be interested in

    Frequently Asked Questions

    • Panda 2012-2026 - How much does it cost to replace the brake pads of a Fiat Panda? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos