Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Front Bumper on Fiat Ducato

Model: Fiat Ducato X290 - Years 2014-2026
Part: Rear bumper

Do you want to replace the front bumper on your Fiat Ducato? Follow these steps to remove the front bumper along with all attached parts. Lift the front bonnet and locate the screws to remove above the bumper. Unscrew the screws securing the central grille, then remove all plastic covers. Unscrew the fastening screws located at the top of the bumper, then remove the screws on the sides of the wheel arch liners. Once the bumper is free from any screws, grasp it with your hands and pull it away from the body. Secure the new bumper and then refit all the plastic parts of the grille.

Updated on 18 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Guide to Removing the Front Bumper of the Fiat Ducato
Guide to Removing the Front Bumper of the Fiat Ducato
Fiat Ducato (2006-2014 / X250) In this brief and simple guide, you will learn how to remove the front bumper of the Fiat Ducato by following the instructions below. First, open the…
Replacement and Cost of the Front Driveshaft for the Fiat Ducato X250
Replacement and Cost of the Front Driveshaft for the Fiat Ducato X250
Fiat Ducato (2006-2014 / X250) This guide provides the main instructions on the cost and replacement of the front driveshaft for the Fiat Ducato X250. Replacing the front driveshaf…
How do you replace the front turn signal bulb of the Fiat Ducato?
How do you replace the front turn signal bulb of the Fiat Ducato?
Fiat Ducato (2006-2014 / X250) In order to replace the front turn signal bulb of the Fiat Ducato, you need to loosen the screws that secure the corresponding side spotlight located…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos