Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Glove Compartment of a Fiat Stilo

Model: Fiat Stilo MK 1 - Years: 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010
Part: Dashboard

Video tutorial

Start by opening the glove compartment. Next, disconnect the internal bulb using a flathead screwdriver and unplug the connector attached to it. Once you have successfully removed the internal bulb, begin unscrewing all the screws inside the glove compartment.

To make the job easier, it is possible, but not mandatory, to press the two tabs on the supports of the door, allowing it to lower further. Once all the screws are removed, you can extract the glove compartment without any obstruction.

When it is fully extracted, you will have completed the disassembly of the glove compartment.


Updated on 19 April 2026 by ScegliAuto


Related tutorials

How to Remove the Glove Compartment of a Fiat Stilo?
How to Remove the Glove Compartment of a Fiat Stilo?
Fiat Stilo (2001-2010 / MK 1) To start, open the glove compartment. Next, disconnect the internal bulb using a flathead screwdriver and unplug the connector attached to it. Once y…
Where is the OBD port of the Fiat Stilo located?
Where is the OBD port of the Fiat Stilo located?
Fiat Stilo (2001-2010 / MK 1) To find the OBD port of your Fiat Stilo, it only takes a few seconds. All you have to do is carefully read the following guide and then follow the va…
How to Remove the Air Filter on a Fiat Stilo
How to Remove the Air Filter on a Fiat Stilo
Fiat Stilo (2001-2010 / MK 1) When servicing the car, do not forget the cabin air filter. Here’s how to change it on a Fiat Panda. The cabin filter is located at the bottom left o…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos