Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How to replace the starter motor of the Fiat 500?

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2022
Part: Starter motor
Operation: How to replace the starter motor of the Fiat 500?

In order to replace the starter motor of the Fiat 500, you need to open the hood so that you can have access to the components inside the engine compartment: it will be necessary to disconnect the battery by removing the power cables and free it from its housing by unscrewing the screws. fixing. Once the battery has been removed, the underlying connector connected to the starter motor can be disconnected; then, by accessing from the lower part of the vehicle, it will be possible to disconnect the additional connectors and unscrew the fixing screws in order to remove the motor and replace it with a new one.


Posted on 21 June 2022 by ScegliAuto

    Frequently Asked Questions

    • 500 2007-2022 - What problems does the Fiat 500 starter have? Read Answer
    • 500 2012-2023 - How to solve the problem of the start & stop not working on the Fiat 500L? Read Answer
    • 500 2007-2021 - How much does it cost to replace the ignition lock of the Fiat 500? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos