Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Engine Mount on the Gearbox Side of the Fiat Panda 169

Model: Fiat Panda 169, MK 2 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Engine mount

See other generations:
Video tutorial

In this video, see how to remove and replace the engine mount on the gearbox side of the Fiat Panda 169, following the instructions below. First, open the bonnet and start by removing the battery control unit; then remove the battery and battery tray, unscrewing all the screws, as shown in the video.

Next, access the engine mount; unscrew the nuts with an 18 mm socket spanner, lifting the gearbox with a jack first; remove the mount and replace it with the new one, following the video to the end!


Updated on 31 May 2026 by ScegliAuto


Related tutorials

How to Remove the Engine Mount Reaction Link in the Fiat Panda 169
How to Remove the Engine Mount Reaction Link in the Fiat Panda 169
Fiat Panda (2003-2012 / 169, MK 2) Today, let’s see how to remove the engine mount reaction link from its seat in the second series of the Fiat Panda, the 169. First, gather a jack or,…
How to Replace the Gear Knob on a Fiat Panda?
Fiat Panda (2003-2012 / 169, MK 2) Before you can start, sit in the driver's seat of your Fiat Panda. It is strongly advised to perform this operation with the engine off, to avoid acc…
How to Replace the Drive Shaft on a Fiat Panda 169 4x4
How to Replace the Drive Shaft on a Fiat Panda 169 4x4
Fiat Panda (2003-2012 / 169, MK 2) Discover in this video the instructions for replacing the drive shaft on a Fiat Panda 169 4x4. First, lift the vehicle and position the jack under th…

Other guides you may be interested in

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos