Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How to replace the spark plugs in the Fiat 500

Fiat 500 - Video tutorial

Model: Fiat 500 - Years 2007-2021
Part: Spark plugs
Operation: How to replace the spark plugs in the Fiat 500

In today's video we see how to replace the spark plugs on the petrol Fiat 500. First we park the car on a level surface and put the handbrake on. We pull the lever and open the engine hood. Now let's start unscrewing the fixing screws of the air tube. We then unscrew the retainers of the air filter cover. Let's pull it away and then proceed to disconnect the hose on the back. We remove the corresponding tube and then proceed to the extraction of the candle in question. Use the appropriate key. Then proceed with the installation of a new key of the same type and you are finished.


Posted on 4 November 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 500 2012-2023 - How do you replace the spark plugs of the Fiat 500L? Read Answer
    • 500 2007-2022 - How much does it cost to replace the Fiat 500 spark plugs? Read Answer
    • 500 2007-2021 - Where are the spark plugs of the Fiat 500 1.3 MultiJet located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos