Do it yourself
Frequently asked questions about cars and motorcycles

How to Clean the Throttle Body of the Fiat Panda 1.2

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Throttle body

Let's look at the instructions on how to remove and clean the throttle body of the Fiat Panda 1.2, following these simple and quick steps. First, open the bonnet of your car and start by removing the plastic cover above the engine, thus taking off the air filter box; then unscrew the securing screws of the throttle body, disconnecting the electrical connector of the throttle position sensor to remove it, as shown in the video. At this point, use appropriate throttle body cleaners to remove all dirt; then reassemble everything!

Updated on 14 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Fiat Panda (2003-2012 / 169, MK 2) In today's tutorial video, learn how to remove and replace the throttle body, as well as clean it, on the Fiat Panda 1.2 Petrol. First, open the bonn…
Fiat Panda (2003-2012 / 169, MK 2) In this short video tutorial, you will see how to remove and clean the MAP air pressure sensor on a Fiat Panda 169. Start by opening the car's bonnet…
Fiat Panda (2003-2012 / 169, MK 2) In this video tutorial, you will learn how to remove and clean the mass air flow sensor from the Fiat Panda second series (169) with a 1.2 8-valve en…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos