Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing and Replacing the Throttle Body on the Fiat Panda 1.2

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Throttle body

In today's tutorial video, learn how to remove and replace the throttle body, as well as clean it, on the Fiat Panda 1.2 Petrol. First, open the bonnet and start by removing the air filter box, unclipping the tabs on the sides; then, unscrew the securing bolts of the throttle body located underneath using a Torx screwdriver, as shown in the video. Disconnect the electrical connector of the position sensor and the accelerator cable to remove it; then proceed with cleaning or directly replacing it!

Updated on 22 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Clean the Throttle Body of the Fiat Panda 1.2
How to Clean the Throttle Body of the Fiat Panda 1.2
Fiat Panda (2003-2012 / 169, MK 2) Let's look at the instructions on how to remove and clean the throttle body of the Fiat Panda 1.2, following these simple and quick steps. First, ope…
How to Adjust a Fiat 750 Carburettor
How to Adjust a Fiat 750 Carburettor
Fiat Panda (1980-2003 / 141, MK 1) Let’s see how to adjust the carburettor on a Fiat 750. Open and lift the front bonnet (secure it); unscrew the two nuts (located above the cover) of …
Removing the Mass Air Flow Sensor from the Fiat Panda 2 (169) 1.2 8V
Removing the Mass Air Flow Sensor from the Fiat Panda 2 (169) 1.2 8V
Fiat Panda (2003-2012 / 169, MK 2) In this video tutorial, you will learn how to remove and clean the mass air flow sensor from the Fiat Panda second series (169) with a 1.2 8-valve en…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos