Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Perform an Oil Service on a Fiat Bravo Diesel

Model: Fiat Bravo Bravo 2 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
Part: Checks and maintenance

See other generations:
Video tutorial

In this video, we demonstrate how to service a Fiat Bravo with a diesel engine. To perform this operation, lift the vehicle and remove the left front wheel and wheel arch liner, as well as part of the engine cover located underneath the vehicle.

This will allow easy access to the sump drain plug and the filter. Drain the used oil into a container for proper disposal at an authorised centre, and do the same with the filter, replacing it with a new one. Apply clean oil to the new gasket before installing it, then refit the drain plug (it is advisable to use a new one), replace the wheel arch liner and engine cover, then reattach the wheel and lower the vehicle.

Now it’s time to refill with approximately 4.8 litres of new oil, which you should measure again after running the engine for about a minute.


Updated on 22 September 2026 by ScegliAuto


Related tutorials

How to replace the diesel filter of the Fiat Bravo 1.6 MultiJet
How to replace the diesel filter of the Fiat Bravo 1.6 MultiJet
Fiat Bravo (2007-2014 / Bravo 2) Below we will discover the steps that will allow us to disassemble and replace the diesel filter of the Fiat Bravo 1.6 MultiJet. First, we open the h…
How to remove the gear knob of the Fiat Bravo
How to remove the gear knob of the Fiat Bravo
Fiat Bravo (2007-2014 / Bravo 2) To disassemble the gear knob located inside the cabin of your Fiat Bravo correctly and safely, you must follow all the steps described in our new gui…
How to Reset the Service Light on the Fiat Bravo?
How to Reset the Service Light on the Fiat Bravo?
Fiat Bravo (2007-2014 / Bravo 2) In this video tutorial, you can see how to reset the maintenance light on the Fiat Bravo with simple essential steps. First, you need to go to an aut…

How to Open the Bonnet of a Toyota C-HR

To open the bonnet of a Toyota C-HR, get inside the vehicle and lift the lever with the bonnet symbol located under the steering wheel. After lifting the lever, you will notice that the bonnet rises a few centimetres. Position yourself in front of the bonnet, insert your hand into the gap, and move the small internal lever from right to left, then lift the bonnet. You can keep the bonnet open during maintenance by positioning it on the support rod. To close the bonnet, remove the support rod and let it drop back down.

Watch the video!


by ScegliAuto

More videos