Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Engine Cylinder Head Gasket

Model: Fiat Bravo - Years 1995-2001
Part: Engine

Let’s see how to replace the engine cylinder head gasket. Remove the alternator belt and any accessory belts (power steering, air conditioning) and unscrew the spark plugs and their respective leads. Once everything is freed, you can extract the valve cover from the cylinder head and thus see the camshaft and timing belt. The timing belt and the engine block have two clearly visible reference marks; before removing the belt, ensure the two marks align perfectly. Once the correct position is found, block the clutch flywheel, located under the oil sump and the timing belt pulley, so it does not move. This operation will help find the top dead centre, which is when the first piston is at the highest point in its stroke. Pay particular attention during the tightening phase of the head with the new gasket to the cylinder block. To do this correctly, you will need a torque wrench to tighten the bolts to the correct torque value.

Updated on 22 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Cylinder Head Gasket in Engine Block
Cylinder Head Gasket in Engine Block
Fiat Bravo (1995-2001 / ) In the engine block, the pistons of the cylinder head move up and down in cylinder holes. These pistons are connected to rods and a crankshaft that p…
Replacement of Intake Manifold Gasket
Replacement of Intake Manifold Gasket
Fiat Bravo (1995-2001 / ) Before proceeding with the installation of the new intake manifold gasket, it is essential to clean the surfaces of both the manifold and the cylinde…
Replacement of Cylinder Head Fixing Pins
Replacement of Cylinder Head Fixing Pins
Fiat Bravo (1995-2001 / ) Before applying the new cylinder head gasket, re-thread the fixing holes on the block, choosing the correct pitch for the tap. During this operation,…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos