Do it yourself
Frequently asked questions about cars and motorcycles

What to do if you hear a squeak from the clutch pedal on a Fiat Punto

Model: Fiat Punto 199, MK 3, Grandepunto , Punto EVO - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016
Part: Clutch

See other generations:
Video tutorial

A squeak from the clutch pedal on a second-generation Fiat Punto is a common issue. The most frequent cause is the clutch hydraulic pump (slave cylinder), which wears out over time and begins to squeak.

However, this is not the only possibility. Other potential causes could be a worn release bearing: you will hear a metallic squeak when pressing the pedal, or the clutch lever or pivot lacking lubrication: you will hear a dry and intermittent squeak, or the receiver cylinder (on the gearbox) leaking or stuck.

What to do? First, check the clutch fluid level; if it is low, top it up and check for any leaks, then lubricate the pedal lever and pivots with lithium grease. If the squeak persists, the pump or release bearing needs replacing.

Do not ignore the problem: a faulty pump can leave you without a clutch. Replacing the pump is a simple job, but it requires bleeding the system.


Posted on 16 August 2026 by ScegliAuto


Related tutorials

Fiat Punto (1999-2011 / MK 2, 188) To bleed the clutch pump in the Fiat Punto, open the bonnet and unscrew the cap of the reservoir containing the clutch fluid. This will allow you to …
Fiat Punto (2005-2018 / 199, MK 3, Grandepunto , Punto EVO) Before you start, lift the car and remove the front left wheel. Begin by opening the bonnet, disconnecting the battery, and removing it. After removi…
Fiat Punto (2005-2018 / 199, MK 3, Grandepunto , Punto EVO) If the clutch pedal is completely soft and offers no resistance, or touches the floor without returning, as shown in the video, the problem is almost…

Other guides you may be interested in

    Frequently Asked Questions

    • Punto 1999-2011 - How much does it cost to replace the clutch on the Fiat Punto 1.2 8v? Read answer

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos