Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Bleed the Clutch Pump in the Fiat Punto?

Model: Fiat Punto MK 2, 188 - Years 1999-2011
Part: Clutch

To bleed the clutch pump in the Fiat Punto, open the bonnet and unscrew the cap of the reservoir containing the clutch fluid. This will allow you to top up by pouring in the new fluid. Next, locate the clutch actuator at the front of the engine bay and adjust its intensity using the appropriate screw indicated in the video. After adjusting, go inside the cabin and fully press the clutch pedal to allow the fluid to flow into the system. Finally, close the reservoir containing the clutch fluid.

Updated on 7 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Clutch Pump on the Fiat Grande Punto
How to Remove the Clutch Pump on the Fiat Grande Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) In today's tutorial, you will see the main steps to remove and replace the clutch cylinder or pump on the Fiat Grande Punto. First, open the bonnet o…
What to do if you hear a squeak from the clutch pedal on a Fiat Punto
What to do if you hear a squeak from the clutch pedal on a Fiat Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) A squeak from the clutch pedal on a second-generation Fiat Punto is a common issue. The most frequent cause is the clutch hydraulic pump (slave cylin…
How to Replace the Clutch Pump on a Fiat Punto
How to Replace the Clutch Pump on a Fiat Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Before you can start, lift the front left side of your Fiat Punto. Begin by unscrewing and removing the bolts that secure the wheel, then remove the …

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos