Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Panda
    4. : How to change Fiat Panda oil and oil filter

Fiat Panda - Video tutorial

Model: Fiat Panda MK 3, 319 - Years 2012-2023
Part: Oil filter
Operation: How to change Fiat Panda oil and oil filter

Respecting the scheduled maintenance intervals both in terms of mileage and time expiration is absolutely essential to preserve the life of the engine; especially with new generation engines, generally supercharged, the quality of the oil is absolutely fundamental; having said this, in order to change the oil on the new Panda (frame 312), in addition to draining the oil from the drain plug located under the sump, the plastic cover on the top of the engine must be removed, which also acts as the engine box. engine air filter; Once the cover has been removed, the engine oil filter is located at the rear of the engine and is of the cartridge type.


Posted on 23 September 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Panda 2003-2012 - Where is the Fiat Panda oil filter located? Read Answer
    • Panda 2012-2023 - How much does a replacement oil filter cost for the Fiat Panda 1.3 Multijet? Read Answer
    • Panda 2003-2012 - Where is the oil filter located in Fiat Panda 1002? Read Answer
    • Panda 2003-2012 - Where is the oil filter on the methane Fiat Panda? Read Answer

Replace the steering angle sensor on the Volkswagen Golf 5

When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components.

Watch the video!


by ScegliAuto

More videos