Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Fit Wheel Spacers on a Ford Cougar?

Model: Ford Cougar MK 1 - Years 1998-2002
Part: Wheel spacers

Here you will find information on how to fit wheel spacers on your Ford Cougar. The steps are very simple and are as follows. First, slightly loosen the wheel support bolts, then lift the car and completely remove the bolts to take off the wheel. Once done, clean the central part of the disc and apply the spacer in the correct position. After this, clean the inner part of the wheel as shown in the video and proceed to refit the wheel. Repeat these simple steps for all four wheels, and you’re done.

Posted on 21 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Water Pump on a Ford Cougar
How to Replace the Water Pump on a Ford Cougar
Ford Cougar (1998-2002 / MK 1) You can replace the water pump on the Ford Cougar by lifting the car so that the front right wheel does not touch the ground: once the wheel is lifte…
How to Replace the Antenna Mount on a Ford Cougar
How to Replace the Antenna Mount on a Ford Cougar
Ford Cougar (1998-2002 / MK 1) To replace the antenna mount on a Ford Cougar, access the interior of the vehicle to disconnect the courtesy light housing. Once this has been remove…
A 1999 Ford Cougar Where the Engine Turns but Won't Start
A 1999 Ford Cougar Where the Engine Turns but Won't Start
Ford Cougar (1998-2002 / MK 1) In this video, you will see a Ford Cougar where the starter motor turns, but the engine does not start. The diagnostic procedure followed was to list…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos