Do it yourself
Frequently asked questions about cars and motorcycles

Complete Oil and Filter Service for Ford B-Max

Model: Ford B Max MK 1 - Years 2012-2018
Part: Engine oil

Change the oil and filters on the Ford B-Max: the pollen filter is located on the passenger side under the dashboard: remove the panel held by a single screw, take out the three screws of the access door and change the filter: an activated carbon filter is recommended as it also retains odours. The air filter is located in the engine compartment, under the cover: loosen the duct clamp, remove the connector, loosen the screws of the cover, remove the old filter and insert the new one. Move on to the windscreen washer fluid: 1 part concentrated fluid and two parts demineralised water. Check the brake fluid level: if it decreases, it is because the pads are wearing and the fluid occupies the space in the caliper cylinders. Check the coolant level when the engine is cold, which should be between minimum and maximum: top up if necessary, with fluid of the same colour as that in the reservoir. The fuel filter is located in the engine compartment: remove the three screws of the support bracket; disconnect the electrical connections (lift the safety tab); disconnect the fuel lines (press the white button to release). Remove the two screws that secure the filter to the housing, then drain the old fuel; open the filter by rotating the top and remove the screws holding the filter holder. Fill the new filter with clean fuel before fitting it (to prevent the system from sucking in air and having difficulty starting). To change the engine oil, lift the front of the car, remove the lower panel, drain the oil by removing the plug and letting it flow into a large container (which we will dispose of correctly at an authorised centre). Also replace the filter (and the gasket). Change the plug and gasket, then refill the oil from above (after bringing the car back to the ground). Fill to the maximum or slightly below. Start the engine for 5 minutes to circulate the oil, then turn off and wait 10 minutes for the oil to settle in the sump. Check the level and add if necessary (it will probably be about half a litre short to fill the cartridge).

Posted on 9 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Ford B Max (2012-2018 / MK 1) How to reset the oil light on a Ford B Max? Let’s look at the reset procedure. Enter the Ford vehicle and turn on the instrument panel, then locate t…
Ford B Max (2012-2018 / MK 1) In this video, we see how to reset the service light of a Ford B Max car. First, get into the car and insert the key into the appropriate slot, turn …
Ford B Max (2012-2018 / MK 1) Need to replace the oil filter on a Ford B Max? Let's see how to remove it from inside the engine bay. Open the car door and pull up the engine bay r…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos