Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the camshaft sensor on a Ford Focus 1.6i 16V

Model: Ford Focus MK 1 - Years 1998-2004
Part: Crankshaft position sensor

Today, you will learn how to remove the camshaft speed sensor on a Ford Focus 1.6i 16 valve, first series. First, open the bonnet of your car and remove the four spark plug leads from the ignition coil; then unscrew the securing screws using a T25 Torx key, disconnecting the electrical connector. At this point, disconnect the electrical connector of the camshaft sensor and unscrew the securing bolt to remove it, as shown in the video. Now you can replace it with the new one and reassemble everything by following the reverse procedure!

Updated on 9 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Ford Focus (2004-2011 / MK 2, Focus 2) In this video we can see where the camshaft position sensor is located in the Ford Focus and how to proceed in case we need to replace it, a very sim…
Ford Focus (2004-2011 / MK 2, Focus 2) This guide provides the main instructions on how to dismantle and replace the timing belt on a Ford Focus 1.6 TDCi. First, raise the vehicle and begi…
Ford Focus (2011-2018 / MK 3) Replacing the timing belt on a car is a complex task that is recommended to be carried out by qualified personnel. Below are the main steps to follow…

Other guides you may be interested in

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos