Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Camshaft Sensor in a Ford Focus?

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Checks and maintenance

As shown in this tutorial, replacing the camshaft sensor in the Ford Focus is an extremely simple and quick task. First, wait for the engine to cool completely, then open the bonnet and locate the sensor on the right side at the top of the engine. To remove it, undo the single securing bolt and disconnect the connector by pressing the relevant clip. Once done, refit the replacement part by following the reverse procedure.

Updated on 28 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Crankshaft Position Sensor on a Ford Focus?
How to Replace the Crankshaft Position Sensor on a Ford Focus?
Ford Focus (1998-2004 / MK 1) To replace the crankshaft position sensor on a Ford Focus, open the bonnet to remove the radiator located at the front of the engine bay. Once the ra…
Replacing the Crankshaft Pulley and Timing Belt on the Ford Focus 1.6
Replacing the Crankshaft Pulley and Timing Belt on the Ford Focus 1.6
Ford Focus (2004-2011 / MK 2, Focus 2) Today, follow the main instructions for removing and replacing the timing belt and crankshaft pulley on the Ford Focus 1.6. First, raise the vehicle …
How to Change the Speed Sensor on a Ford Focus
How to Change the Speed Sensor on a Ford Focus
Ford Focus (1998-2004 / MK 1) This brief guide outlines the steps to remove and replace the speed sensor on a Ford Focus. First, locate the speed sensor on the engine block; this …

    Frequently Asked Questions

    • Focus 2004-2011 - What problems encountered on the Ford 1.6 tdci 90 hp engine? Read answer
    • Focus 2004-2011 - Where is the outside temperature sensor of a Ford Focus located? Read answer
    • Focus 1998-2004 - Where is the immobilizer of a Ford Focus located? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos