Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Fiesta
    4. : How to replace the MAF sensor of a Ford Fiesta

Ford Fiesta - Video tutorial

Model: Ford Fiesta MK 6, Fiesta 6, MK VI - Years 2008-2017
Part: Mass air flow sensor
Operation: How to replace the MAF sensor of a Ford Fiesta

Before we can begin, we will have to go and open the front hood of our Ford Fiesta. The MAF sensor is located inside the top cover of the air cleaner block. So let's start by unhooking and disconnecting the relative electrical connector. After that, we will have to go and unscrew and remove the two screws that secure the MAF sensor to the air filter block. By doing so, we will have freed the sensor itself. At this point, we can go to extract the sensor from its housing. When we have completed this last step, we will have successfully completed the disassembly. To mount the new sensor, we will only have to follow these steps in reverse, and we will have completed the replacement.


Posted on 1 February 2024 by ScegliAuto

    Frequently Asked Questions

    • Fiesta 2002-2008 - What is the problem with the intake of the Ford Fiesta 1.4 TDCi? Read Answer
    • Fiesta 2008-2017 - How to solve the Ford Fiesta TDCi flow meter problem? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos