Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Reversing Light Bulbs in the Ford Ranger?

Model: Ford Ranger MK 3 - Years 1998-2011
Part: Tail light bulb

Replacing the reversing light bulbs in the Ford Ranger is a simple and quick task. Let's see how to proceed in the attached video tutorial. Start by unscrewing the two outer screws of the light unit using a cross-head screwdriver. Next, unscrew the other two inner screws, accessible from the boot. At this point, pull the light unit from its housing and disconnect the connector. The bulb in question is the one located at the bottom, inserted in the green bulb holder. Replace it with an equivalent model, 3157, and reassemble everything by following the reverse procedure. Repeat the operation for the opposite light unit if necessary.

Updated on 28 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Light on Ford Ranger
How to Replace the Rear Light on Ford Ranger
Ford Ranger (2015-2019 / ) Let's see how to replace the rear light on the Ford Ranger. To remove the light, unscrew the securing screws. Use a socket or screwdriver to unscrew …
Removing the Interior Light Fitting on a Ford Ranger T6-T7
Removing the Interior Light Fitting on a Ford Ranger T6-T7
Ford Ranger (2015-2019 / ) In this video, we will see how to remove the interior light fittings and replace the bulbs on a Ford Ranger T6 and T7 in simple and quick steps. Firs…
How to reset the service light on the Ford Ranger
How to reset the service light on the Ford Ranger
Ford Ranger (2011-2023 / T6, P375, PX) For the manual reset of the service light on the display of the instrument panel of your Ford Ranger, you do not necessarily need to seek the help of…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos