Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Intake Manifold of the Ford Focus 1.6

Model: Ford Focus MK 3 - Years 2011-2018
Part: Checks and maintenance

To remove the intake manifold of the Ford Focus 1.6, first open the bonnet to remove the plastic cover from the top of the engine block. Once this is removed, you can loosen the first screws that secure the intake manifold, particularly the one on the fastening ring that connects it to the exhaust manifold. Next, disconnect the coils connected to the injectors, and you can unscrew the bolts that secure the manifold at the rear: this way, the part can be pulled out and replaced if necessary.

Updated on 8 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Dismantle the Intake Manifold on a Ford Focus?
How to Dismantle the Intake Manifold on a Ford Focus?
Ford Focus (2004-2011 / MK 2, Focus 2) In this tutorial, you will see how to dismantle the intake manifold on a Ford Focus, a task that requires good manual skills. First, lift the front l…
Intake Manifold Gasket Replacement
Intake Manifold Gasket Replacement
Ford Focus (1998-2004 / MK 1) Before applying the new gasket to the intake manifold, thoroughly clean the gasket seating area, removing any dirt and deposits that could compromise…
Intake Manifold Gasket Replacement
Intake Manifold Gasket Replacement
Ford Focus (2004-2011 / MK 2, Focus 2) The intake manifold gaskets are actually o-ring seals applied inside specific grooves made at the ends of the intake manifold itself, which must then…

    Frequently Asked Questions

    • Focus 2004-2011 - What problems encountered on the Ford 1.6 tdci 90 hp engine? Read answer
    • Focus 2004-2011 - Where is the outside temperature sensor of a Ford Focus located? Read answer
    • Focus 1998-2004 - Where is the immobilizer of a Ford Focus located? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos