Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace a Broken Bracket on the Driver's Door of a 2020 Ford Escape

Model: Ford Escape MK 4 - Years 2020-2026
Part: Checks and maintenance

As mentioned in the video, if your 2020 Ford Escape is still under warranty, it's better not to do this DIY job and take it to a shop where they will likely replace the entire door for a total cost of about $2,500 or more. However, sometimes time is tight, the door won't close, and the wipers can also get damaged. After removing the driver's door interior panel by unscrewing the screws, detaching the panel, and disconnecting the connector, proceed to replace the broken welded bracket. In the video, three holes will be made in the bracket and the body, and rivets will be inserted. Once the bracket is secured, reinstall the panel.

Updated on 4 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Driver's Window Regulator in a Ford Escape?
How to Replace the Driver's Window Regulator in a Ford Escape?
Ford Escape (2008-2012 / MK 2) In this tutorial, you will see how to replace the driver's window regulator mechanism in a Ford Escape. This is a simple task but requires good manua…
Removing the Rear Hatch Panel of the Ford Escape
Removing the Rear Hatch Panel of the Ford Escape
Ford Escape (2008-2012 / MK 2) In today's tutorial video, you will learn how to remove and replace the rear hatch panel of the Ford Escape in simple and quick steps. First, open th…
How to Remove the Rear Hatch Panel on a Ford Escape
How to Remove the Rear Hatch Panel on a Ford Escape
Ford Escape (2013-2019 / MK 3) Today, you will learn how to remove and replace the rear hatch panel on a Ford Escape. First, open the trunk and start removing the plastic trim piec…

How to Replace the Diesel Filter of the Peugeot 3008 1.5 BlueHDI

Briefly, we will see the main instructions for dismantling and replacing the diesel filter of the Peugeot 3008 1.5 BlueHDI. First, locate the diesel filter under the vehicle, so it will be necessary to lift it; then disconnect the electrical connector and the fuel lines from the filter, unscrewing the side screws to remove the cartridge, as shown in the video. At this point, replace the diesel filter with the new one, as well as with the original one; then reconnect the pipes and the electrical connector, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos