Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace Engine Mounts on Ford Focus tdCi

Model: Ford Focus MK 1 - Years 1998-2004
Part: Engine mount

The deterioration of the rubber inside the engine mounts can cause not only noise, especially during starting and braking, but also excessive engine vibration, compromising the vehicle's road holding; it is therefore essential to replace all three: there is one under the engine connecting it to the cradle and two upper side mounts located near the shock absorber strut tops; therefore, place a support jack under the engine and proceed with the replacement of the lower mount before moving on to the side ones (for the passenger side mount, the radiator tank must be removed).

Updated on 22 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Engine Mount on Ford Focus 1.6 TDCi
Ford Focus (2004-2011 / MK 2, Focus 2) In this tutorial, you will learn how to remove and replace the engine mount on a second-generation Ford Focus. First, open the bonnet and remove the …
How to Replace the Injectors of the Ford Focus 1.6 TDCi?
Ford Focus (2004-2011 / MK 2, Focus 2) To replace the injectors of the Ford Focus 1.6 TDCi, open the bonnet to access the engine bay and remove the plastic cover from the top of the engine…
Replacing the Glow Plugs on the Ford Focus 1.6 TDCI
Replacing the Glow Plugs on the Ford Focus 1.6 TDCI
Ford Focus (2004-2011 / MK 2, Focus 2) The following steps will show you how to remove and replace the glow plugs on the Ford Focus 1.6 TDCI, following the instructions below. First, open …

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos