Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Fog Light from the Ford Escape

Model: Ford Escape MK 2 - Years 2008-2012
Part: Fog lights

In this video tutorial, you will see the steps to remove and replace the fog light on the Ford Escape, following the instructions below. First, remove the front wheel well liner to access the inside of the fog light; then disconnect the electrical connector and remove the mounting screws to take it out, as shown in the video. At this point, replace the fog light bulb if necessary or the entire assembly; reconnect the electrical connection and test its operation, finally reinstalling the front wheel well liner!

Updated on 19 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the fog light bulb of the Ford Escape
How to replace the fog light bulb of the Ford Escape
Ford Escape (2013-2019 / MK 3) To replace the fog light bulbs of the Ford Escape car model produced from 2013 to 2019, we need to use a 7mm wrench to unscrew the clips on the wheel…
How to Replace the Front Fog Lights on a Ford Escape
How to Replace the Front Fog Lights on a Ford Escape
Ford Escape (2001-2007 / MK 1) In this guide, learn how to remove and replace the front fog lights on a Ford Escape. First, lift the vehicle and start by removing the screws locate…
How to activate the fog lights in the Ford Escape?
How to activate the fog lights in the Ford Escape?
Ford Escape (2013-2019 / MK 3) In this tutorial we can see how to activate the fog lights in the Ford Escape, an extremely simple and quick operation, to be carried out only in the…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos