Do it yourself
| ||||
|
Ford Escape - Video tutorial
Model: Ford Escape
MK 3
- Years 2013-2019 In this video we can see how to find a faulty TPMS sensor on the tires of our Ford Escape. Initially, the YouTuber thought it was interference from other electronic devices, but after eliminating them all, the problem continued to reoccur, so he decided to replace the faulty sensor. We recommend - when one fails - to replace them all, as they are usually activated all at the same time. However, if you prefer to replace only one, then make sure to have a tester to check the sensors. We need to put the car in programming mode, and it is very easy. We put the key in the ignition and press the brake once and turn the key three times. Press the brake and turn off again, turn on and turn the key three times again. We will hear a "beep". We are in programming mode. Now we approach the tester to the valve. If the sensor is working, we will hear a honk, otherwise it will remain silent.
Posted on 29 April 2024 by ScegliAuto
Where is the fuel pressure sensor located in the Ford Escape?
Ford Escape (2001-2007 / MK 1) In this video, we can see where the fuel pressure sensor is located in the Ford Escape and how to proceed in case we need to replace it. As shown, th
How to replace the third brake light bulb on the Ford Escape - Kuga
Ford Escape (2013-2019 / MK 3) Let's see below the steps that will allow us to disassemble and replace the third brake light bulb of the Ford Escape, but also of the Kuga. First of
How to replace the lambda probe in the Ford Escape?
Ford Escape (2008-2012 / MK 2) In this tutorial we can see how to replace the lambda sensor in your Ford Escape. The first things to do, in order to operate in complete safety, are Other guides that may interest you
|
Frequently Asked QuestionsFiat Ducato 2.8 JTD gearbox oil replacementLet's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.060
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |