Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Genesis
    3. :
  3. G70
    4. : How to replace the front brake discs on the Genesis G70

Genesis G70 - Video tutorial

Model: Genesis G70 MK 1 - Years 2018-2024
Part: Brake discs
Operation: How to replace the front brake discs on the Genesis G70

In this video tutorial we will see how to remove and replace the front brake discs and pads of the Genesis G70, in simple steps. First of all we lift the car and start by removing the front wheel; after which we unscrew the fixing screws of the brake caliper, which we find on the rear, in order to remove it from the disc. At this point we use a Phillips screwdriver to unscrew the brake disc screws, in order to remove it, as shown in the video; then we replace the disc with the new one, of the right type, finally installing the new brake pads!


Posted on 1 May 2024 by ScegliAuto



How to replace the front brake pads of the Genesis G70.
Genesis G70 (2018-2024 / MK 1) In today's video tutorial, we will see how to disassemble and replace the front brake pads of the Genesis G70, following the instructions below. Firs
How do i replace the brake pads on the Genesis G70?
Genesis G70 (2018-2024 / MK 1) The replacement of the brake pads of the Genesis G70 is the same for both the rear and the front wheels. It will be necessary to go and lift the car,
How do you remove the front bumper of the Genesis G70?
Genesis G70 (2018-2024 / MK 1) In order to remove the front bumper of the Genesis G70 you have to open the hood, so that you can loosen the screws that secure the bumper from the t

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos