Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Genesis
    3. :
  3. G80
    4. : How to replace the battery in the remote control of the Genesis G80?

Genesis G80 - Video tutorial

Model: Genesis G80 MK 2, DH - Years 2016-2020
Part: Key
Operation: How to replace the battery in the remote control of the Genesis G80?

Replacing the battery of the Genesis G80 remote control is a very simple and fast operation, let's see how to proceed in this tutorial. To do this, we will only need a small flat-tip screwdriver and a spare CR2032 battery. First, we hold down the side button and extract the metal emergency key, then we unlock the two halves of the remote control by levering with the screwdriver in the slot opposite that of the key. Once the remote control is opened, we can remove the old battery and insert the replacement one, obviously in the right direction.


Posted on 21 May 2024 by ScegliAuto



How to replace the battery of the Genesis G80
Genesis G80 (2016-2020 / MK 2, DH) Let's see in this guide how to disassemble and replace the battery of the Genesis G80, in simple and quick steps. First of all we open the tailgate o
How to start the Genesis G80 when the key does not work
Genesis G80 (2016-2020 / MK 2, DH) If you can't start your Genesis G80 normally because the smart key stopped working suddenly don't worry because below we will explain how to fix the
Where is the fuse box located in the Genesis G80?
Genesis G80 (2016-2020 / MK 2, DH) To successfully and safely locate the fuse box inside your Genesis G80 (year 2016-2020) in a few seconds, follow these steps. First, enter the car an

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos