Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Genesis
    3. :
  3. Gv80
    4. : How to replace engine oil on Genesis Gv80

Genesis Gv80 - Video tutorial

Model: Genesis Gv80 JX1, MK 1 - Years 2020-2024
Part: Engine oil
Operation: How to replace engine oil on Genesis Gv80

In order to carry out the filter on the car, it is necessary to proceed as follows: first of all, open the bonnet, lift the car onto the bridge, remove the small cover panel under the engine to access the oil drain plug. Then unscrew the cap and place a container underneath to collect the used oil, wait a few minutes for all the oil to drain out and screw the cap back on. Go back to the upper part of the bonnet, disassemble the air duct, and under it there is the filter, with a socket wrench unscrew the cap, extract the filter and position the new one, taking care to replace the o-ring gasket. Then refit the cap and proceed to filling the circuit with new oil, always checking the specifications set for the oil by the manufacturer.


Posted on 15 December 2022 by ScegliAuto



How do you change the engine oil of the Genesis GV80?
Genesis Gv80 (2020-2024 / JX1, MK 1) In order to change the engine oil of the Genesis GV80 you have to unhook the rivets that secure the protective panel of the lower part of the car, so
How do you remove the rear light of the Genesis GV80?
Genesis Gv80 (2020-2024 / JX1, MK 1) To replace the rear light of the Genesis GV80, you need to open the rear door of the car so that you can access the plastic cover located next to the
How do you open the rear hatch of the Genesis GV80?
Genesis Gv80 (2020-2024 / JX1, MK 1) Different methods can be used to replace the rear hatch of the Genesis GV80: first, it is possible to press the button located at the base of the rea

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos