Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Genesis
    3. :
  3. G80
    4. : How to change engine oil on Genesis G80

Genesis G80 - Video tutorial

Model: Genesis G80 MK 2, DH - Years 2016-2020
Part: Engine oil
Operation: How to change engine oil on Genesis G80

Let's see below how to replace the engine oil and relative filter on the car. First of all, open the bonnet, remove the oil dipstick and unscrew the filler cap, then lift the car and proceed to remove the fixing screws of the sound absorbing panels located under the engine, once you have identified the oil drain plug, proceed to unscrew it not before placing a container on the floor to collect the used oil. wait a few minutes so that all oil has come out, after which identify the oil filter and with a socket wrench unscrew the cap and remove it, inside the cap there will be the cartridge that will have to be replaced, always remember to replace the o-ring gasket as well . Then replace the cartridge and screw the filter cap back on, also screw the oil drain plug back on, and return to the top of the engine compartment. Then fill the circuit with new lubricant and close the filler cap. Finally measure the oil level with the dipstick.


Posted on 4 December 2022 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos