Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil of the GMC Sierra?

Model: GMC Sierra MK 4 - Years 2014-2018
Part: Engine oil

To change the engine oil of the GMC Sierra, access the underside of the vehicle and loosen the drain plug. This will allow you to collect all the used oil in a properly positioned container. When the oil has completely drained, close the drain plug and refill through the engine compartment. It is recommended to use 0W-20 oil through the designated fill hole located on the right side of the engine; once the necessary oil has been added, close it with the cap.

Updated on 8 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil in a GMC Sierra?
How to Change the Engine Oil in a GMC Sierra?
GMC Sierra (2007-2014 / MK 3) To change the engine oil in a GMC Sierra, access the bottom of the engine bay, where you will find the oil drain plug. By unscrewing this plug, you c…
How to Reset the Oil Light on a 2016 GMC Sierra
How to Reset the Oil Light on a 2016 GMC Sierra
GMC Sierra (2014-2018 / MK 4) If you notice the oil pressure light stays on when you start your 2016 GMC Sierra, even after changing the oil and filter, follow these steps to manu…
Reset the Oil Light on GMC Sierra
Reset the Oil Light on GMC Sierra
GMC Sierra (2014-2018 / MK 4) In this video tutorial, you can see how to reset the engine oil light on a 2016 GMC Sierra. First, perform maintenance on your vehicle, including an …

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos