Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Tail Light Bulbs of the GMC Savana

Model: GMC Savana MK 2 - Years 2003-2024
Part: Tail light bulb

This brief and simple guide shows the steps to remove and replace the tail light bulbs of the GMC Savana. First, open the rear hatch of the trunk and start unscrewing the mounting screws located on the sides of the tail light using a 10 mm socket wrench; once the cover is removed, you can take out the tail light by disconnecting the electrical connector of the bulbs, as shown in the video. At this point, remove the bulb holders and bulbs, replacing them with new ones; finally, reassemble everything!

Updated on 23 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Headlight on a GMC Savana?
How to Replace the Headlight on a GMC Savana?
GMC Savana (1996-2002 / MK 1) To replace the headlight on a GMC Savana, loosen the screws around the headlight that secure it in its housing; once these screws are loosened, detac…
How to Replace the Headlight on a GMC Savana
How to Replace the Headlight on a GMC Savana
GMC Savana (1996-2002 / MK 1) To replace the headlight on this vehicle model, refer to the description below and the tutorial video for all necessary information and steps to corr…
How to Replace the Key Battery for GMC Savana
How to Replace the Key Battery for GMC Savana
GMC Savana (1996-2002 / MK 1) Thanks to the very simple and minimalist design of your GMC Savana key, replacing the battery inside is particularly easy and quick. Below, you will …

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos