Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Great Wall
    3. : Voleex

Removing the Front Door Panel of the Great Wall Voleex

Model: Great Wall Voleex MK 1 - Years 2010-2016
Part: Door trim panel

Today's instructions will show you how to remove and replace the front door panel of the Great Wall Voleex. First, open the front door and start unscrewing all the fixing screws found on the door panel, removing the various plastic caps located on the side and inside the handle; then gently detach the panel from the sides, as shown in the video. At this point, disconnect the handle cable and the electric connector of the window switch, reassembling and securely fixing the door panel!

Updated on 12 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Cabin Filter in the Great Wall H6?
How to Replace the Cabin Filter in the Great Wall H6?
Great Wall Great Wall H6 (2011-2016 / MK 1) In this tutorial, you will see how to replace the cabin filter in the Great Wall H6, a very simple and quick operation. First, go inside the cabin, t…
Can you make a ramp to lift a Great Wall vehicle?
Can you make a ramp to lift a Great Wall vehicle?
Great Wall Great Wall H6 (2011-2016 / MK 1) Everyone has, at least once in their life, needed to lift their vehicle for a check or to carry out a job. Whether it’s a Great Wall car or any other…
How to Reset the Great Wall H6
How to Reset the Great Wall H6
Great Wall Great Wall H6 (2011-2016 / MK 1) Performing a forced reset on a 2021 Great Wall H6 is a very simple operation that can be done independently, aided by this short video tutorial. It i…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos