Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Front Brake Discs and Pads

Model: Honda Civic MK 7 - Years 2001-2006
Part: Brake pads

Loosen the wheel fixing bolts before lifting the vehicle, then raise it with a jack (or on a lift) and complete the wheel removal. Unscrew the two fixing bolts of the brake disc from the hub. Next, unscrew the two fixing bolts of the brake caliper (located at the rear) and remove the caliper itself along with the pads. Proceed to remove the brake caliper support to take off the disc from the hub. Clean the hub of any oxidation residue, apply grease, reposition the new disc, and tighten the respective fixing bolts. Refit the brake caliper support (after cleaning it with a wire brush) and insert the new pads. Compress the brake caliper piston using a clamp and finally refit it, tightening the respective fixing bolts. Refit the wheel. Pump the brake pedal until it offers the correct resistance.

Updated on 4 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Front Brake Pads
Honda Civic (2006-2012 / MK 8) Lift the vehicle on suitable axle stands and remove the front wheel (loosen the wheel nuts before lifting it). Then unscrew the retaining pins of the…
How to Replace the Rear Brake Pads on a Honda Civic
How to Replace the Rear Brake Pads on a Honda Civic
Honda Civic (2006-2012 / MK 8) To replace the rear brake pads on a Honda Civic, lift the car so that the rear wheel is off the ground. Next, undo the bolts securing the wheel in it…
How to Replace the Front Brakes on a Honda Civic Mk8
How to Replace the Front Brakes on a Honda Civic Mk8
Honda Civic (2006-2012 / MK 8) This guide shows how to replace the front brakes on a Honda Civic Mk8. Using a 19 mm spanner, loosen the bolts on the front wheels and lift the vehic…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos