Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Front Wheel Bearing on a Honda CR-V

Model: Honda CR-V MK 4 - Years 2012-2017
Part: Bearing

To replace the front wheel bearing on your vehicle, follow the instructions below and refer to the video. First, remove the front wheel. Then, loosen the bolts securing the brake caliper and remove them. Expand the caliper to remove the brake pads from the disc. Next, detach the caliper support. Remove the steering arm nut and disconnect it from the driveshaft. At this point, you can extract the brake caliper assembly after also unscrewing the lower suspension support. You will then have access to the bearing, which can be extracted using a suitable puller.

Updated on 30 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Crankshaft Position Sensor on Honda CR-V 2.4L
How to Replace the Crankshaft Position Sensor on Honda CR-V 2.4L
Honda CR-V (2002-2007 / MK 2) These brief and simple steps will show you how to remove and replace the crankshaft position sensor on the Honda CR-V. First, lift the vehicle and st…
How to replace the petrol filter on the Honda CR-V?
How to replace the petrol filter on the Honda CR-V?
Honda CR-V (2002-2007 / MK 2) To replace the petrol filter on the Honda CR-V, lift the car with a jack so that the left rear wheel is off the ground: once lifted, loosen the bolts…
Replacing the Front Control Arm on a Honda CR-V
Replacing the Front Control Arm on a Honda CR-V
Honda CR-V (2007-2012 / MK 3) To replace the front control arm on the Honda CR-V, proceed as follows: 1) Lift the vehicle using suitable jacks. 2) Remove the front wheel. 3) Remov…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos