Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. I10
    4. : How to replace the headlight bulb on a Yundai I10

Hyundai I10 - Video tutorial

Model: Hyundai I10 MK 1, PA - Years 2007-2013
Part: Tail light
Operation: How to replace the headlight bulb on a Yundai I10

Replace damaged rear light bulbs? Let's see the disassembly. We open the hood of the luggage compartment, then, we unscrew the tightening screws on the side of the rear light. Once the headlight is removed, disconnect the power supply terminals connected to the headlight and pull it away from its seat. We replace damaged bulbs with new ones (same voltage) on hand. We reassemble the lighthouse in its housing (we connect the electrical terminals), we screw the tightening screws on the sides of it. We turn on the instrument panel with the key and test the operation of the new bulbs. We replace all damaged rear and front light bulbs.


Posted on 23 December 2023 by ScegliAuto



How to replace the headlight bulb Hyundai I10
Hyundai I10 (2007-2013 / MK 1, PA) In this very simple video guide we will see how to remove the headlight bulb of a Hyundai I10. The disassembly operation takes a few minutes and is n
How to replace the front headlight bulb of the Hyundai i10.
Hyundai I10 (2013-2020 / MK 2, IA) Replacing the left front headlight bulb of the Hyundai I10 is a very simple operation, easily performed independently, thanks to our short video tuto
How to replace the headlight bulb on Hyundai I10?
Hyundai I10 (2013-2020 / MK 2, IA) To be able to replace the headlight bulb of the Hyundai I10 you have to open the hood to access the engine compartment and turn the protective cap of

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos