Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Sonata
    4. : Engine oil and oil filter replacement

Hyundai Sonata - Video tutorial

Model: Hyundai Sonata - Years 2004-2014
Part: Oil filter
Operation: Engine oil and oil filter replacement

If possible, raise the car on a lift or on suitable car platforms to facilitate access to the underside of the vehicle. Then remove the plastic cap to access the oil pan drain; then unscrew the drain plug, complete the emptying and tighten the plug again by repositioning the plastic protection. Still accessing from below, unscrew the oil filter (it is located a little further ahead than the oil sump) and apply the new one after having covered the gasket with oil (it is sufficient to tighten by hand). Finally, fill the engine with new oil according to SAE specifications and the quantities indicated in the use and maintenance manual; check the level through the appropriate stick.


Posted on 28 July 2023 by ScegliAuto



Engine oil and filter replacement
Hyundai Sonata (2004-2014 / ) Replacing the engine oil and its filter is the typical do-it-yourself maintenance: it is recommended to dispose of the used oil at a special collecti
Engine oil and oil filter replacement
Hyundai Sonata (2004-2014 / ) Raise the car on suitable car platforms to facilitate access to the oil pan. The lower stone guard is equipped with special slots to access the oil d
Engine oil and oil filter replacement
Hyundai Sonata (2004-2014 / ) The oil filter is a cartridge type and is located in the center right of the engine (when viewed from the front), near the sleeve that connects the a

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos