Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Elantra
    4. : Automatic gearbox oil change

Hyundai Elantra - Video tutorial

Model: Hyundai Elantra MK 2, J2 - Years 1995-2000
Part: Gear oil
Operation: Automatic gearbox oil change

Replacing the oil in the gearbox, especially in the case of automatic transmission, will benefit the operation of the transmission itself and the engagement will certainly become more regular; it basically involves draining the used oil through the special drain plug on the bottom of the gearbox and then inserting the new fluid through the cannula in which the oil level control stick is housed, located near the engine air filter box; once the new fluid has been inserted, start the engine and engage all the gears to make it circulate in all the actuators.


Posted on 12 September 2023 by ScegliAuto



Instructions for checking the gearbox oil level
Hyundai Elantra (1995-2000 / MK 2, J2) On the gearbox there are generally two plugs: a lower one to drain the oil and one positioned on the side of the gearbox itself through which to fill
Drive shaft replacement instructions
Hyundai Elantra (2006-2010 / HD, MK 4) Raise the car on a lift and remove the front wheel; using a wire cutter, remove the safety pin located on the nut fixing the drive shaft in the cente
Disassembly of the car clutch
Hyundai Elantra (1995-2000 / MK 2, J2) The following guide shows how to change the car's clutch. The replacement requires several steps which, if done correctly, save some money. The work

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos